Olympus VISERA CLV-S40 - Video System Connection Guidelines

30
Chapter 3 Installation and Connection
VISERA XENON LIGHT SOURCE CLV-S40
• Do not connect unnecessary cables to the video system to
be used. It may damage the equipment, and operator and/or
patient injury may result.
• Do not connect more than one video system to the
instrument at one time. It may damage the equipment, and
operator and/or patient injury may result.
• When using a video system with BNC cables, connect the
BNC cables to the VIDEO IN/OUT connectors on the light
source’s rear panel and turn OFF the video system’s
electrical shutter mode. Otherwise, the automatic brightness
may not operate properly, and operator and/or patient injury
may result.
• To avoid damaging electrical contacts and/or causing a
malfunction, do not apply excessive force to any connector.
• In combination with some non-Olympus video system, the
automatic brightness control may not operate properly, and
endoscopic observation and treatment may be impossible.
Video system
Cable
Light control
cable
BNC cable
Olympus video system
OTV-S5, OTV-S6, OTV-S7V,
OTV-SX, OTV-SX2
{ ×
Video system with BNC
cable (Olympus video
system, OTV-SE)
× {
Video system without BNC
cable
××
No video system
××
{ necessary × unnecessary