CMC 356 Reference Manual
102
7.4 Three-Phase Current Mode with High Burden
3 x 0 ... 32 A (±45 A
DC
), max. 70 V
peak
, 3 x 860 VA at 25 A
For loads with three separate phases it is possible to double the available
compliance voltage. However, this configuration does not make sense, if a
common N connector is required! Do not connect N1, N2 and N3 to each
other!
Observe the safety instructions given in Section 7.1 on page 95 when using
this operating mode.
Figure 7-8:
Three-phase operation
To Next Page
Loading...
