Operating the CMC 356
19
3.4 Starting the Test System
The following description assumes that the computer has been set up and
that the test software for the OMICRON Test Universe has been installed.
At this point of time you may want to have a look at the Getting Started
with Test Universe manual. This manual guides you through the first steps
and actions with the Test Universe software. Learn
• how to associate a CMC test set with your computer and what to do if the
association won't work
• about the Test Universe Start Page
• how to output voltages and currents with your CMC test set using the
QuickCMC test module
• how to set up a test with Test Object and Hardware Configuration.
This manual is provided in PDF format. It is available on your hard disk after
the installation of OMICRON Test Universe. To view the manual, start the
Test Universe Help from the Start Page or any test module and navigate to
the table of contents entry User Manuals (at the beginning of the table of
contents). Click Test Universe Software Manuals. In this topic you find a
direct link at "Getting Started". To view the manual, click the link.
This description refers both to the computer and to the CMC 356. It does not
take into consideration any external devices. If the system is driven by
external amplifiers, follow the instructions in section 7.5, "Operation with
External Amplifiers" on page 103.
When setting up the CMC 356, make sure not to obstruct the ventilation
slots.
To Next Page
Loading...
Need help?
General
