Omnicomm Profi - Page 80

Firmware Change Log
Date Firmware
Version
Changes
July 26,
2018
FW 305 - upgraded GPS connection (satellite loss, track gaps solved)
- failure after page reloading rectified
- track gaps in case of CS failure eliminated
January
14,
2019
FW 307 - solved factory reset issue when cleaning the terminal data archive or in
case of on-board network voltage drop
- enhanced GPS communication (eliminated periodic coordinate
discarding at 00-00 UTC)
- solved a problem of lack of communication with Profi Wi-Fi terminals, if
there is a 0 in IP-address (for example, 192.168.0.1)
- rectified freezing of Omnicomm LLS-AF fuel level sensor values when
the terminal switches to Collect all except GPS mode
March
20,
2019
FW 308 - implemented the function of collecting arbitrary CAN-parameters from
VH operating according to FMS, and displaying CAN data in
Omnicomm Online
- terminal factory reset eliminated
- solved failures of terminal time stamps, VID, PID
- added protection from satellite loss due to QZSS (Japanese Quasi-Zenith
Satellite System)
- implemented the function of the terminal calling back to the number in
case of bad voice connection
80
Firmware Change Log