Omron DRT1 Series - Page 155

139
Analog I/O Terminals Section 4-8
Components of the DRT1-AD04 and DRT1-AD04H
DIP Switch Settings The following diagram shows the functions of the DIP switch on the DRT1-
AD04 and DRT1-AD04H Analog Input Terminals.
DIN track mounting hooks
DeviceNet Indicators
Communications connector
DIP switch
Pins 1 to 6: Node address setting
Pins 7 and 8: Baud rate setting
Pin 9: Number of inputs setting (4 points or 2 points) [DRT1-AD04 only]
Pin 10: Averaging function setting [DRT1-AD04 only]
Rotary switch
Sets the input ranges.
Terminal block
(Refer to page 312.)
(Refer to page 124.)
(Refer to page 147.)
(Refer to page 146.)
(Refer to page 124.)
Open-circuit Indicators (DRT1-AD04H only)
(Refer to page 147.)
Corresponding indicator lights when open
circuit is detected.
Node address setting
Baud rate
DRT1-AD04 DRT1-AD04H
Not used. (must
be OFF.)
Number of in-
puts setting
(4 pts. or 2 pts.)
Averaging
function setting