Omron DRT1 Series - Page 341

325
Using Another Company’s Master Unit Appendix B
Note 1. The bit strobe connection is supported only when the output size is set to 0 bytes and the input size
is set to 8 bytes.
2. The data sizes can be changed.
3. The device profiles below contain more detailed DeviceNet specifications if more information needs
to be registered in the scan list.
Device Profiles for Regular and Environment-resistive Slaves
The following device profiles contains more detailed DeviceNet specifications for General-purpose and Envi-
ronment-resistive Slaves if more information needs to be registered in the scan list.l
Environment-resistive Transistor
Ter minal s
DRT1-ID08C Yes Yes No No 1 0
DRT1-HD16C Yes Yes No No 2 0
DRT1-HD16C-1 Yes Yes No No 2 0
DRT1-OD08C Yes No No No 0 1
DRT1-WD16C YesNoNoNo0 2
DRT1-WD16C-1 Yes No No No 0 2
DRT1-MD16C Yes No No No 1 1
DRT1-MD16C-1 Yes No No No 1 1
Waterproof Terminals DRT1-ID04CL Yes Yes No No 1 0
DRT1-ID04CL-1 Yes Yes No No 1 0
DRT1-ID08CL Yes Yes No No 1 0
DRT1-ID08CL-1 Yes Yes No No 1 0
DRT1-OD04CL Yes No No No 0 1
DRT1-OD04CL-1 Yes No No No 0 1
DRT1-OD08CL Yes No No No 0 1
DRT1-OD08CL-1 Yes No No No 0 1
B7AC Interface Unit DRT1-B7AC Yes Yes No No 4 0
C200H I/O Link Unit C200HW-DRT21 Yes Yes
(See
note 1.)
No No 0 to 64
(See
note 2.)
0 to 64
(See
note 2.)
RS-232C Unit DRT1-232C2 Yes Yes No No 2 0
Slave group Model Connection type Data sizes
poll bit
strobe
change
of state
cyclic IN OUT
General data Compatible DeviceNet Specifications Volume I - Release 1.3
Volume II - Release 1.3 (See note)
Header name OMRON Corporation Header ID = 47
Device protocol name Slaves: Generic Protocol number = 0
Manufacturer catalog number W347
Manufacturer revision 1.0