Omron fh series Hardware Setup Manual

Dimensions.................................................................... 3-8
FH-5050 for 3D Robot V
ision
Specification...................................................................3-2
FH Application Software.................................................... 1-4
FH-MT12........................................................................... 1-6
FH-SMDA-GS050B........................................................... 1-3
FH-UM3D1........................................................................ 1-4
FH-VMDA £M................................................................... 1-6
FH-VMRGB....................................................................... 1-6
FH-VSDX.........................................................................3-15
FH-VSDX-BX.....................................................................1-3
FH-VSDX-LBX...................................................................1-3
FH-VUAB £M....................................................................1-6
FHV-VNBX............................................................... 1-3, 3-13
FHV-VNLBX............................................................. 1-3, 3-13
FH-XCAL-R.............................................................. 1-5, 3-17
FH-XCAL-S.............................................................. 1-5, 3-17
FH-XCN............................................................................. 1-2
F-LINK-E 0.5mm x 4P..................................................... 1-10
Flow of Use Procedure...................................................... 2-5
FL Series........................................................................... 1-7
FLV-ATC Series................................................................. 1-7
FLV Series......................................................................... 1-7
FZ-DU................................................................................1-8
FZ-M08.............................................................................. 1-6
FZ-MEM2G........................................................................1-8
FZ-MEM8G........................................................................1-8
FZ-VM................................................................................1-6
G
General Compliance Information and Instructions for EU. 1-2
GX-JC03............................................................................
1-8
H
Handeye Calibration Target............................................... 1-5
HandEye calibration target
.............................................. 3-17
Handling and Installation Environment.............................. 4-1
FH-5050......................................................................... 4-2
Handling a SD memory card............................................. 4-4
Handling of Sensor Controller.................................... 4-2, 4-3
HMC-SD291...................................................................... 1-8
HMC-SD491...................................................................... 1-8
I
I/O (Parallel) connector (control lines, data lines)..............3-5
I/O Cables..........................................................................
1-3
I/O Interface.......................................................................6-1
EtherCAT Interface.......................................................6-11
Ethernet Interface........................................................ 6-13
Parallel Interface............................................................ 6-2
IETP-SB...........................................................................1-10
Imaging unit..................................................................... 3-10
Industrial Switching Hubs for EtherNet/IP and Ethernet....1-8
Insert/Remove SD Memory Card or USB memory..........5-15
FH-5050....................................................................... 5-15
Installation and Storage Sites............................................4-3
Installation Environment.................................................... 4-2
Installation in a Control Panel..........................................5-17
FH-5050
....................................................................... 5-17
Installation of 3D Vision Sensor.......................................5-11
Instruction Installation Manual for FH series..................... 1-2
Instruction sheet................................................................ 1-2
Internal Specifications for Parallel Interface...................... 6-8
K
KETH-PSB-OMR............................................................. 1-10
KETH-SB.........................................................................
1-10
L
L/A IN.................................................................................3-7
L/A OUT.............................................................................
3-7
LCD and Cable................................................................ 3-25
Component Names and Functions.............................. 3-26
Dimensions.................................................................. 3-27
Wire..............................................................................3-26
LCD Monitor
Dimensions.................................................................. 3-27
Specification.................................................................3-25
LCD Monitor 8.4 inches for Box-type Controllers.............. 1-6
LCD Monitor and Cable..................................................... 1-6
LCD Monitor Cable............................................................ 1-6
Specification.................................................................3-25
LED indicator lamp.......................................................... 3-20
LED indicator lamp (for power)........................................3-26
LED indicator lamp (for SYNC)........................................3-26
Lighting.............................................................................. 1-7
Lighting Controller............................................................. 1-7
For FLV-Series............................................................... 1-7
M
Maintenance...................................................................... 4-3
Membership registration
.................................................... 1-2
Monitor...............................................................................1-6
Monitor Cable: FZ-VM
Dimensions.................................................................. 3-27
Monitor connector (analog RGB).....................................3-20
Mounting of Sensor Controller...........................................5-7
Mouse................................................................................1-8
MPS588...........................................................................1-10
MPS588-C....................................................................... 1-10
N
NETSTAR-C5E SAB 0.5 x 4P CP....................................1-10
O
Operation indicator.......................................................... 3-10
Orientation of Product
........................................................4-3
OSD Menu button............................................................3-20
Overview of FH series....................................................... 2-1
Index
I-3
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
I

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB