Omron NX1P2 series

A thin flat-blade screwdriver such as the one shown below is required to connect or remove
cables.
Side view
Front view
1 mm max.
2 mm max.
Wiring to the D-sub Connector
This section explains how a communications cable which is connected to the NX1W-CIF01 is connect-
ed to an external device through wiring to a D-sub connector.
Use the following steps to wire connectors.
See the following diagrams for the length of the cable portion to be cut in each step.
1 Cut the cable to the required length.
2 Remove the specified length of the sheath.
Be careful not to scratch the braided shield.
40 mm (RS-232C)
3 Trim off the braided shield using scissors.
10 mm
4 Remove the insulation from each conductor using a stripper.
5 mm
5 Fold back the braided shield.
6 Wrap an aluminum foil tape around the folded shield.
Aluminum foil tape
5 Installation and Wiring
5-72
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)