Loading Camera Settings
Setting Procedure
1. Select “UserSet X” (or Default) at “UserSetSelector”
2. Execute “UserSetLoad”
Loading Camera Settings when Camera Power is on
Setting Procedure
1. Set “UserSet X” or “Default” at “UserSetDefault”
Camera Settings Initialization
Please follow the procedure in below for camera settings put back to factory default settings.
Setting Procedure
1. Selects “Default” at “UserSetSelector”.
2. Executes “UserSetLoad”.
3. Select “UserSet X” at “UserSetSelector”.
4. Executes “UserSetSave”.
When executing “UserSetLoad”,
camera settings load from selected ROM
that was selected at “UserSetSelector” to
register at RAM.
When the camera power is on,
camera settings load from selected ROM
that was selected at “UserSetDefault” to
register at RAM.
To Next Page
Loading...
