10.18 Event Control
The camera internal signal can be output as specified event information, like “exposure end”, to PC used by
GVCP (GigE Vision Control Protocol).
e.g. Event control
Notified “Exposure End”
Event notification selection
Selection: “Action Late”, “Frame Trigger”, “Exposure Start”, “Exposure End”,
“Frame Start”, “Frame End”, “Block Discard”,
“Line 0 Input Rising Edge”, “Line 0 Input Falling Edge”,
“Line 2 Input Rising Edge” and “Line 2 Input Falling Edge”
Event notification ON / OFF selection
On: Enable event notification
Off: Disable event notification
To Next Page
Loading...
