Omron STC-MBS122BPOE

No.19S207-00
49/73
STC-MBS122BPOE / STC-MCS122BPOE
Product Specifications and User’s Guide
10.12 Trigger
The trigger type (trigger source) is selectable at “TriggerSource” under “AcquisitionControl”.
The trigger type (trigger source) is listed in below table.
Software
Software trigger generates by “TriggerSoftware”
SoftwareSignal0
Software trigger generates by “SoftwareSignalControl”
SoftwareSignal1
Software trigger generates by “SoftwareSignalControl”
Action0
Action command trigger
Line0
Hardware trigger through “Line0”
Line2
Hardware trigger through “Line2”
LogicBlock0
Trigger generates by “LogicBlockControl”
Please refers “Trigger signal processing procedure” for more details
Trigger signal processing procedure
The camera internal process for external hardware trigger signal or software trigger signal input is below:
Line 0
Line 2
Debounce
Debounce
󳆟AND󳆠
or
󳆟OR󳆠
Line 2
Action 0
Line 0
Software
Software Signal 0
Software Signal 1
Logic Block 0
Trigger
Source
Trigger Delay
Camera
Timing
Generator
Sensor
The trigger signal is selectable by GenICam commands.
TriggerSource: select trigger type