FFC function procedure
FFC function procedure
1. Selects “Start calculating FFC correction values” under “File” on menu at “StViewer”.
2. The FFC correction values calculate automatically. The image stops while FFC correction
values are calculating.
3. When FFC correcting values are calculated, sets “True” at “FFC Enable” automatically and FFC
function applied image are acquired.
4. It is necessary to save FFC settings to memory on camera used by “UserSet Control”.
Please refers 10.1 Save and load the camera settings
Image before FFC function Image after apply FFC function
* Note1: Please sets “OFF” for “Trigger mode” as free-run operation when using FFC function.
* Note2: Please adjusts “Exposure Time” to acquiring “50%” brightness level of image when
using FFC function.
* Note3: Please uses FFC function again when changing lens or light source
To Next Page
Loading...
