What to do if there is a FAL error on Omron SYSMAC C200HS?
If you encounter a FAL error on your Omron Controller, it means that FAL(06) has been executed in the program. The solution is to check the FAL number to determine the conditions that led to its execution, as set by the user, and correct the issue accordingly.
Why is my Omron Controller waiting for Remote I/O?
If your Omron Controller is waiting for Remote I/O, it could be due to the power to the Remote I/O Unit being off or a missing terminator. Check the power supply to the Remote I/O Units, the connections between the Remote I/O Units, and the terminator setting to resolve this issue.
How to fix Omron SYSMAC C200HS when waiting for Special I/O or Interrupt Input Units?
If your Omron Controller is waiting for Special I/O or Interrupt Input Units, it indicates that a Special I/O Unit or Interrupt Input Unit has not initialized. To solve this, perform the I/O Table Read operation to check the unit numbers. If a unit is indicated by “$” in the I/O table, replace it. Note that High-density I/O Units may not appear on the I/O Table Read display for all peripheral devices.
General| Model | C200HS |
|---|---|
| Manufacturer | Omron |
| Series | SYSMAC |
| Humidity | 10 to 90% RH (non-condensing) |
| Programming Language | Ladder logic |
| Program Memory | RAM/EPROM/EEPROM |
| Communication Protocols | SYSMAC LINK, SYSMAC NET |
| Communication Ports | RS-232C, RS-422 |
| Power Supply | 100-240V AC, 24V DC |
| Operating Temperature | 0 to 55°C |
| Vibration Resistance | 10 to 57 Hz, 0.075mm amplitude |
To Next Page
