Appendix CProgramming Console Operations
179
*Modes in which the given instruction is applicable: R = RUN, M = MONITOR, P = PROGRAM
Operation/Description Key sequenceModes*
DM Data Save, Restore,
Compare
The procedures for transferring
DM area data to and from tape,
and for comparing it, are
basically the same as for the
Program Memory, given above.
The exceptions are that start
and stop addresses are not
required, and the DM area is
specified instead of the
Program Memory. Each
operation will continue through
to the end of the tape unless
cancelled by pressing clear.
P
EXT
CLR
[File no.]
VER
B
1
Start tape recorder
playback.
SHIFT
SHIFT
REC
RESET
PLAY
SET
Start tape recorder re-
cording.
5 second leader tape
PROM Writer Operations
Operation/Description Modes* Key sequence
PC to PROM Writer
Outputs Program Memory to
the RS–232C interface for
writing to a commercial PROM
writer.
P
Start PROM writer
reception
PROM Writer to PC
Read Program Memory data
from a commercial PROM
writer into the PC via the
RS–232C interface.
P
Start PROM writer
transmission
To Next Page
Loading...
Need help?
General
