Omron SYSMAC CS Series User Manual

xv
About this Manual:
This manual describes the installation and operation of the CS-series CS1W-LCB01 and CS1W-
LCB05 Loop Control Boards, CS1D-CPU@@P Process-control CPU Units, and CJ1G-CPU@@P Loop-
control CPU Units, and includes the sections described below.
The CS-series CS1W-LCB01 and CS1W-LCB05 Loop Control Boards, CS1D-CPU@@P Process-con-
trol CPU Units, and CJ1G-CPU@@P Loop-control CPU Units help you build an instrumentation system
comprising multiple loops. A Loop Control Board is installed as an Inner Board in the CPU Unit of a
CS-series PLC (Programmable Controller).
The CS1W-LCB01 and CS1W-LCB05 Loop Control Boards must be installed in CS1-H CPU Units.
They cannot be used in CS1 CPU Units.
Please read this manual and the other manuals related to the CS1W-LCB01 and CS1W-LCB05 Loop
Control Boards, CS1D-CPU@@P Process-control CPU Units, and CJ1G-CPU@@P Loop-control CPU
Units carefully and be sure you understand the information provided before attempting to install and
operate the products. The manuals used with the CS1W-LCB01 and CS1W-LCB05 Loop Control
Boards, CS1D-CPU@@P Process-control CPU Units, and CJ1G-CPU@@P Loop-control CPU Units
are listed in the following table. The suffixes have been omitted from the catalog numbers. Be sure you
are using the most recent version for your area.
When using CS1D Process-control CPU Units, refer to the following manuals for information on the
CS1D CPU Unit elements.
Name Contents Cat. No.
(suffixes omitted)
SYSMAC CS/CJ Series
CS1W-LCB01, CS1W-LCB05, CS1D-
CPU@@P, and
CJ1G-CPU@@P
Operation Manuals
Describes the basic running of the Loop Control
Boards (excluding detailed descriptions of the
function blocks).
W406
SYSMAC CS/CJ Series
CS1W-LCB01, CS1W-LCB05,CS1D-
CPU@@P, and CJ1G-CPU@@P
Function Block Reference Manual
Provides detailed information on the function
blocks.
W407
SYSMAC CX-One FA Integrated Tool
Package
CXONE-AL@@C-V4/AL@@D-V4
CXONE-LT@@C-V4
Setup Manual
Provides an overview of the CX-One FA Integrated
Tool and installation procedures.
W463
SYSMAC CS/CJ Series
CX-Process Tool
Operation Manual
Describes operation of the CX-Process Tool. W372
Faceplate Auto-Builder for NS
Operation Manual
Describes operation of the software that generates
NS-series PT projects from a SCADA CSV file out-
put by the CX-Process Tool.
W418
Name Contents Cat. No.
(suffixes omitted)
SYSMAC CS Series
CS1D-CPU
@@H, CS1D-DPL01
CS1D-PA/PD
@@@
CS1D Duplex System
Operation Manual
Describes the setup and operation of CS1D
Duplex systems.
W405

Omron SYSMAC CS Series Specifications

General

Brand	Omron
Model	SYSMAC CS Series
Category	Controller
Language	English