Omron SYSMAC CS Series

35
Outline Section 1-1
Function
Blocks (con-
tinued)
Types of Function
Blocks (continued)
DO to Computer Function block for CX-Process Monitor software
The CX-Process Monitor software cannot be used for the Loop
Control Boards, Process-control CPU Units, or Loop-control
CPU Units.
The CX-Process Monitor Plus can be used for the Loop Control
Board.
AO to Computer
1-Block Send Ter-
minal to Computer
4-Block Send Ter-
minal to Computer
DO Terminal to All
Nodes
User link table
AO Terminal to All
Nodes
DO Terminal Set-
tings from Com-
puter
AO Terminal Set-
tings from Com-
puter
DI Terminal From
All Nodes
AI Terminal From
All Nodes
DI 8-point Termi-
nal
DI 16-point Termi-
nal
DI 32-point Termi-
nal
DI 64-point Termi-
nal
DO 5-point Termi-
nal
DO 8-point Termi-
nal
DO 12-point Ter-
minal
DO 16-point Ter-
minal
DO 32-point Ter-
minal
DO 64-point Ter-
minal
DI 16-point/DO
16-point Terminal
DI 96-point Termi-
nal
DO 96-point Ter-
minal
DI 48-point/DO
48-point Terminal
Area Item Loop Control
Unit
Loop Control
Board
Process-control
CPU Unit
Loop-control CPU
Unit