CONTENTS
Introduction .............................................................................................................. 1
Intended Audience...........................................................................................................................................1
Applicable Products .........................................................................................................................................1
Manual Structure...................................................................................................... 2
Page Structure.................................................................................................................................................2
Icons ................................................................................................................................................................3
Safety Precautions................................................................................................... 7
Precautions for Safe Use ........................................................................................ 8
Precautions for Correct Use ................................................................................... 9
Regulations and Standards .................................................................................. 10
Related Manuals..................................................................................................... 11
Revision History
..................................................................................................... 12
Section 1 Communication Specifications Overview
1-1 Confirming the System Configuration ...............................................................................1 - 2
1-1-1 V430-F Series System Configuration ........................................................................................1 - 2
1-2 Communicating with an External Device...........................................................................1 - 4
1-2-1 Basic Control Operations of the Code Reader..........................................................................1 - 4
1-2-2 Applicable Communications Protocols for the V430-F Series...................................................1 - 5
Section 2 Controlling Operation and Data Output with Parallel I/O
2-1 Controlling Operation and Data Output with Parallel I/O.................................................2 - 2
2-1-1 Basic Operation with a Parallel I/O Connection ........................................................................2 - 2
2-1-2 Wiring and Electrical Specifications for Parallel I/O ..................................................................2 - 3
2-1-3 Change the Behavior of Operation............................................................................................2 - 5
2-1-4 Change the Type of Trigger.......................................................................................................2 - 6
2-1-5 Timing Charts for each Trigger Mode........................................................................................2 - 7
2-1-6 Sample Ladder Program ...........................................................................................................2 - 8
2-1-7 Change the Assignments for the Output Signal (Output 1 to 3) ON Condition .........................2 - 9
2-1-8 Change the ON/OFF timing of the Output Signal (Output 1 to 3) ...........................................2 - 17
2-1-9 Change the Polarity of Output Signal (Output 1 to 3)..............................................................2 - 20
2-1-10 Controlling Operation with Signals from an External Device...................................................2 - 21
Section 3 Controlling Operation and Data Output with Ethernet
3-1 Controlling Operation and Data Output with EtherNet/IP ................................................3 - 2
3-1-1 EtherNet/IP Overview................................................................................................................3 - 2
3-1-2 Communication with the Code Reader over EtherNet/IP Connection.......................................3 - 4
3-1-3 Communication Flow Between PLC and Code Reader ............................................................3 - 5
3-1-4 Communication Settings (EtherNet/IP) .....................................................................................3 - 6
3-1-5 T
ag Data Link Setting Methods .................................................................................................3 - 8
3-1-6 Status and Control Signals for Each Input and Output Assembly...........................................3 - 11
CONTENTS
5
V430-F Series Autofocus Multicode Reader User Manual for Communication Settings
To Next Page
Loading...
