Section 7 Errors and Countermeasures
V680S Command Errors
You can check errors detected by the Reader/Writer in the Response Area where the Reader/Writer
returns the response after command execution.
You can also check error information by sending the GET COMMAND ERROR LOG command to the
Reader/Writer or by using the Error Log View on a browser. The following table provides detailed error
information and countermeasures.
Error name Error code Countermeasure
Command parameter error 1005 hex Check the contents of the command and send the correct contents.
Make sure the command parameter values are correct.
Execution status error 1006 hex Send the command again.
Execution is not possible because the Reader/Writer is performing other
processing.
To Next Page
Loading...
