Section 2 Using Communication Diagnostic and the RF Analyzer
Using Communication Diagnostic and the RF Analyzer
You can use communications diagnostics from a Web server. Use either of the following procedures. Use the
Web server to use the RF Analyzer.
Using the Web Server
Enabling Communication Diagnostic
1. Connect the Ethernet cable, turn ON the power supply to the Reader/Writer, and then start a Web
browser on a computer.
2. Specify the IP address of the Reader/Writer in the address field of the web browser.
Enter http://192.168.1.200/ if you are using the default IP address.
3. The Communications Setting View will be displayed.
http:// (IP address)
To Next Page
Loading...
