Opticon NLV-5201 - Auto Trigger

Chapter-2
Before Using
NLV-5201 User's Manual
21
1st
Auto Trigger
2.8.2
Power-OFF
Standby
[Auto Trigger]
Auto Trigger Sleep
Configured
(Default is 60 seconds)
Power
applied
Read
Scanning completes
or
Time out
Non-Operation
Detect target
Detect target
Transition command
Recovery
command
Status Description
Status
Description
Read
Processes reading. Illumination fully ON
Auto trigger standby
When the target is within the scan area and detected, the scanner
starts the reading mode. AIM pulses.
Auto trigger sleep
Auto-trigger mode will sleep after 60 seconds (default time). This sleep
time can be re-configured or disabled.
Reading operation stop*
Operation of the scanner is stopped.
* "Reading operation stop” is configured using commands. This cannot be done while using USB-HID interface.