Chapter-7
Tuning and Bank Function
Bank Function
7.4
Various setting parameters can be registered to bank No.1-7 in bank function. Registering bank
according to operation is possible.
Parameters that can be registered to bank: Tuning value, Read code setting, String option etc.
Parameters that cannot be registered to bank: Interface setting, Read operation setting etc.
Bank Selection 7.4.1
Initial value of the bank operates at No.1. To select bank, use the following setting.
Select bank ab
Effective value: a=0, b=1-7
Bank Specify Trigger
7.4.2
The bank specify trigger operate as a combine of bank selection and trigger “Z” command. This allows
executing with 1 command.
Bank specify trigger*
Effective value: a=0, b=1-7
* To end reading, use “Y” command just like “Z” command.
Confirm Current Bank 7.4.3
To confirm current bank number, use the following setting.
Display the current bank with 2 digits (00-07).
* When in default and bank initialized, “00” as bank default will be displayed.
Initialize Bank 7.4.4
Initialize bank ab setting parameter
Effective value: a=0, b=1-7
Initialize all banks setting parameter.
* Settings that are not included in the bank parameters will not be initialized.
* When bank is initialized, the scanner operates with the default bank as long as bank with effective parameter is not selected.
To Next Page
Loading...