Opticon NLV-5201 - Buzzer and Indicator; Disable Reading Operation; Enable;Disable Mode Key; Reboot the Scanner

Chapter-3
Configurations
NLV-5201 User's Manual
38
1st
Disable Reading Operation
3.3.6
To enable/disable the processing of reading, use the settings below.
Auto trigger become invalid by setting this disable reading. In this setting, menu labels cannot be read,
only commands via serial communication are supported.
Item
Command
Description
Default
Remark
Enable/Disable
Reading operation
[EAT
Enable module reading operation

Command only
[EAU
Disable module reading operation
Command only
Buzzer and Indicator 3.3.7
These commands reflect “4.1.1 Buzzer” and “4.1.2 Good Read Buzzer”.
Item
Command
Description
Remark
Buzzer
B
Sound the good read beep
Command only
E
Sound the error beep
Status LED
L
Flash the status LED
N
Flash the error status LED
Reboot the Scanner 3.3.8
Use this command to restart the scanner.
Item
Command
Description
Remark
Software reboot
RV
Reboot the scanner
Enable/Disable Mode Key 3.3.9
Item
Command
Description
Default
Enable/Disable
Mode key
[EHB
Q0
Disable mode key
Q1
Enable mode key

Mode Key
Control Panel