Optimum OPTImill BF 20V - Operator positions; Safety measures during operation

Version 4.0.2 dated 2019-4-3Page 12 Translation of the original instructions
BF20V | BF20L | BF20LDGB
BF20V_BF20L_BF20LD_GB_1.fm
OPTIMUM
MASCHINEN - GERMANY
®
Electrical specialist
Due to his professional training, knowledge and experience as well as his knowledge of respec-
tive standards and regulations the electrical specialist is able to perform works on the electrical
system and to recognise and avoid any possible dangers himself.
The electrical specialist is specially trained for the working environment in which he is working
and knows the relevant standards and regulations.
Specialist staff
Due to his professional training, knowledge and experience as well as his knowledge of rele-
vant regulations the specialist staff is able to perform the assigned tasks and to recognise and
avoid any possible dangers himself.
Instructed persons
Instructed persons were instructed by the operating company about the assigned tasks and any
possible risks in case of improper behaviour.
INFORMATION
Everyone involved in the assembly, commissioning, operation and maintenance must
 be duly qualified,
 strictly follow these operating instructions.
In the event of improper use
 there may be a risk to the staff,
 there may be a risk to the drilling milling machine and other material values,
 the correct function of the drilling-milling machine may be affected.
1.7 Operator positions
The operator’s position is in front of the drilling-milling machine.
1.8 Safety measures during operation
CAUTION!
Risk due to inhaling of health hazardous dusts and mist.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. To do so, use a
suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using
inflammable auxiliary materials (e.g. spirit) it is necessary to take additional preventive
measures in order to safely avoid health risks.
1.9 Safety devices
Use the drilling-milling machine only with properly functioning safety devices.
Stop the drilling-milling machine immediately if there is a failure on the safety device or if it is
not functioning for any reason.
It is your responsibility!