Optimum OPTImill BF 20V - Operation; Safety; Control and indicating elements

Version 4.0.2 dated 2019-4-3Page 26 Translation of the original instructions
BF20V | BF20L | BF20LDGB
BF20V_BF20L_BF20LD_GB_4.fm
OPTIMUM
MASCHINEN - GERMANY
®
4 Operation
4.1 Safety
Commission the drilling-milling machine only under the following conditions:
 The drilling-milling machine is in proper working order.
 The drilling-milling machine is used as intended.
 The operating manual is followed.
 All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the drilling-milling machine immediately in
the event of any abnormality in operation and make sure it cannot be started up accidentally or
without authorisation.
 "For your own safety during operation“ on page 16
4.2 Control and indicating elements
Img.4-1: Drilling-milling machine
Pos. Designation Pos. Designation
1 Cover of draw-in rod 2 Control panel
3 Digital display fine crossfeed of spindle sleeve 4 Spindle protection
5 Crank for height adjustment of the drill-mill head 6 Selector switch for reduction stage
7 Star grip for spindle sleeve feed 8 Activation of the fine adjustment
9 Fine adjustment of spindle sleeve
1
2
3
4
5
6
7
8
9