Optimum OPTImill BF 20V - The main menu; LCD display parameter setting; Parameter setting of X Y Z-axis and speed axis

Version 4.0.2 dated 2019-4-3Page 40 Translation of the original instructions
BF20LDGB
BF20LD_GB_DRO5.fm
OPTIMUM
MASCHINEN - GERMANY
®
5.4 The main menu
In the normal display state, press and hold the "PROG" key for three seconds to enter the main menu.
LCD display setting
LCD display setting: the secondary menu, press "PROG" key to enter to modify the LED display parame-
ter.
Unit selection
Press "PROG" key to enter the menu, mm/inch as a select.
Language selection
Press "PROG" key to enter the menu, English/German as a select.
Working mode
Press "PROG" key to enter and select,
 X Y Z
 X Z0+Z Z
 2X Y Z
Decimal point
Decimal place setting. Selection of decimal places, 2 or 3 decimal places.
Channel setup
Multilevel menus, press the "PROG" key to enter the menu, to modify X Y Z as well as the speed axial
parameter.
Operation
The introductions of the main functions
Save and Exit
Saving new parameters, press the "PROG" key to confirm, then return to the normal display state.
5.4.1 LCD display parameter setting
Contrast
Press the "PROG" key to enter the menu, selection range is 0~31, the increment or decrement is 1.
Backlight
Press the "PROG" key to enter the menu, selection range is 0~63, the increment or decrement is 1.
Test sample
Selection of three different RGB display types.
Press the "PROG" key to enter the menu, selection range is 0~3, the increment or decrement is 1.
Save and Exit
Saving new parameter, press "PROG" key to confirm, then return to the main menu.
5.4.2 Parameter setting of X Y Z-axis and speed axis
X-axis parameter
Three-level menu, press "PROG" key to enter to modify the X-axis parameter.
Y-axis parameter
Three-level menu, press "PROG" key to enter to modify the Y-axis parameter.
Z-axis parameter
Three-level menu, press "PROG" key to enter to modify the Z-axis parameter.