exa1sw-ip#write memory
Building configuration...
Compressed configuration from 3784 bytes to 1465 bytes [OK ]
exa1sw-ip#show clock
21:00:06.643 EST Mon Aug 9 2017
13. After setting the local time zone, you can configure up to two NTP servers.
exa1sw-ip#configure terminal
Enter configuration commands,one per line.End with CNTL/Z.
exa1sw-ip(config)#ntp server 10.7.7.32 prefer
exa1sw-ip(config)#ntp server 198.51.100.19
exa1sw-ip(config)#end
*Sep 15 14:51:08.665:%SYS-5-CONFIG_I:Configured from console by
console
exa1sw-ip#write memory
Building configuration...
Compressed configuration from 2654 bytes to 1163 bytes [OK ]
exa1sw-ip#show ntp status
<output will vary per network>
exa1sw-ip#show clock
21:00:23.175 EST Mon Aug 9 2017
The preceding should show the NTP server synchronized to local time if the Cisco
switch is connected to the network that has access to the NTP server.
14. Verify the configuration using the following command:
exa1sw-ip#show running-config
Building configuration...
Current configuration : 3923 bytes
!
! Last configuration change at 02:40:49 GMT Wed Nov 12 2014
!
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
service compress-config
!
hostname exa1sw-ip
!
boot-start-marker
boot system bootflash:cat4500e-ipbasek9-mz.152-3.E2.bin
boot-end-marker
!
enable secret 5 $1$mS8h$EaJrIECUxavfGH6vLZg1T.
enable password welcome1
!
username admin password 0 welcome1
!
aaa new-model
!
!
aaa session-id common
ip subnet-zero
ip domain-name example.com
ip name-server 10.7.7.3
ip name-server 198.51.100.5
Chapter 5
Configuring the Cisco Ethernet Switch
5-11
To Next Page
Loading...
Need help?
General