completions of a device/filename.]
grub> root (hd0,0)
Filesystem type is ext2fs, partition type 0x83
grub> setup (hd0)
Checking if "/boot/grub/stage1" exists... no
Checking if "/grub/stage1" exists... yes
Checking if "/grub/stage2" exists... yes
Checking if "/grub/e2fs_stage1_5" exists... yes
Running "embed /grub/e2fs_stage1_5 (hd0)"... failed (this is not fatal)
Running "embed /grub/e2fs_stage1_5 (hd0,0)"... failed (this is not fatal)
Running "install /grub/stage1 (hd0) /grub/stage2 p /grub/grub.conf "...
succeeded
Done.
grub> quit
7. Run
ibhosts
and verify that all nodes show the correct IP addresses and host
names. There should be no nodes with
elasticNode
in the description.
8. Run the OEDA tool to deploy.
[root] # ./install.sh -cf ../MAA-dm01.xml -l
1. Validate Configuration File
2. Setup Capacity-on-Demand
3. Create Virtual Machine
4. Create Users
5. Setup Cell Connectivity
6. Create Cell Disks
7. Create Grid Disks
8. Configure Alerting
9. Install Cluster Software
10. Initialize Cluster Software
11. Install Database Software
12. Relink Database with RDS
13. Create ASM Diskgroups
14. Create Databases
15. Apply Security Fixes
16. Install Exachk
17. Setup ASR Alerting
18. Create Installation Summary
19. Resecure Machine
Related Topics:
• Exadata 12.1.2.1.1 release and patch (20240049) (My Oracle Support Doc ID
1959143.1)
5.8.2 Using Elastic Configuration to Image a New System
Elastic configuration is now the standard methodology for all new deployments, and
applies to Oracle Exadata X5, X5-2L, and X4-8b (with X5 storage cells) servers. You
can also use the same process to add additional database servers or cells to an
existing configuration. The process allows initial IP addresses to be assigned to
database servers and cells, regardless of the exact customer configuration ordered.
Elastic configuration is only applicable to machines shipped from the factory (or to
machines imaged exactly to mimic that) and only for X5 and X4-8b systems or later
generations. You can run Elastic configuration at the first time of deployment, and
when adding new X5 factory-built components to a rack. You cannot use Elastic
configuration to configure or reconfigure systems. It is recommended that you use
Elastic configuration only with machines shipped from the factory for first-time
deployment.
Chapter 5
Imaging a New System
5-65
To Next Page
Loading...
Need help?
General