Name: Oracle EXADATA X6-2
Brand: Oracle
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Note:

• When using the KVM switch, and pressing the ESC key, the BIOS may

receive two ESC characters, and prompt to exit. Select CANCEL.

• If you need to connect to the ILOM serial management port, then the baud

rate setting on Exadata Storage Servers is changed from the default ILOM

setting 9600 to 115200 baud, 8 bits, no parity, and 1 stop bit.

1. Log in as the

root

user to the first Exadata Storage Server.

Note:

If you do not have the password for the

root

user, then contact Oracle Support

Services.

2. Verify the SysSN label for the cell matches the

product_serial_number

value using

the following command:

#ipmitool sunoem cli "show /SYS product_serial_number"

Connected.Use ^ D to exit.

->show /SYS product_serial_number

/SYS

Properties:

product_serial_number =0937XFG03B

->Session closed

Disconnected

3. Check the hardware and firmware using the following command:

# /opt/oracle.SupportTools/CheckHWnFWProfile

If output does not show success, then examine the output for mismatched

hardware or firmware and take steps to correct those as explained in next steps in

this section.

4. Verify the disks on the server are visible and online using the following command.

The disks are numbered slot 0 to slot 11.

#cd /opt/MegaRAID/MegaCli

#./MegaCli64 -Pdlist -aAll |grep "Slot \|Firmware"

Slot Number:0