Performing Initial Configuration (CLI)
For detailed information, see “NTP Configuration” in Oracle ZFS Storage Appliance
Administration Guide, Release OS8.6.x.
Configure Time. Configure the Network Time Protocol.
Subcommands that are valid in this context:
help [topic] => Get context-sensitive help. If [topic] is specified,
it must be one of "builtins", "commands", "general",
"help", "script" or "properties".
show => Show information pertinent to the current context
commit => Commit current state, including any changes
abort => Abort this task (potentially resulting in a
misconfigured system)
done => Finish operating on "ntp"
enable => Enable the ntp service
disable => Disable the ntp service
get [prop] => Get value for property [prop]. ("help properties"
for valid properties.) If [prop] is not specified,
returns values for all properties.
set [prop] => Set property [prop] to [value]. ("help properties"
for valid properties.) For properties taking list
values, [value] should be a comma-separated list of
values.
hostname:maintenance system setup ntp> set servers=0.pool.ntp.org
servers = 0.pool.ntp.org (uncommitted)
hostname:maintenance system setup ntp> commit
hostname:maintenance system setup ntp> done
aksh: done with "ntp", advancing configuration to "directory" ...
5.
Configure name services.
For detailed information, see “Configuring Services” in Oracle ZFS Storage Appliance
Administration Guide, Release OS8.6.x.
206 Oracle ZFS Storage Appliance Installation Guide • December 2016
To Next Page
Loading...
Need help?
General