OPTIMOD-FM INTRODUCTION
1-23
D) Press and hold Locate right to the System Setup: Network/Remote 2 screen.
E) Select the desired Remote Interface input (1-8), using Locate button.
F) Turn the control knob to display Bypass, then press the Enter button.
G) Locate to a different Remote Interface input, turn the control knob to display Exit
Test
, then press the Enter button.
H) Place the 8400 in Bypass mode by remote control.
a) Switch the 8400 into Bypass mode by a momentary command from your
station’s remote control to the input programmed as
Bypass.
b) Begin EAS broadcast.
c) When the EAS broadcast is finished, switch the 8400 from Bypass mode by a
momentary command from your station’s remote control to the input
programmed as
Exit Test.
You may also choose to insert EAS broadcast tones and data directly into the transmitter,
thus bypassing the 8400 for the duration of the EAS tones and data broadcast.
Warranty, Feedback
The warranty, which can be enjoyed only by the first end-user of record is located on the
inside back cover of this manual. Save it for future reference. Details on obtaining factory
service are provided in Section 5.
User Feedback Form
We are very interested in your comments about this product. Your suggestions for im-
provements to either the product or the manual will be carefully reviewed. A postpaid
User Feedback Form is provided in the back of this manual for your convenience. If it is
missing, please write us at the address printed in the front of the manual, or call or fax our
offices at the number listed. We will be happy to hear from you.
To Next Page
Loading...
