OPTIMOD-FM INSTALLATION
2-55
If you revert to connecting from PC Remote via your computer’s serial port
(either via direct connect, RAS null modem, or through a modem) then you
must enter the following IP address into 8400.ini:
192.168.168.101
[carriage return]
Do not enter the words “carriage return”; instead, add a carriage return by pressing the
Enter key on your computer’s keyboard.
192.168.168.101 is the data in the default 8400.ini file that is installed auto-
matically when you install the PC Remote application. If the IP address in this file is
wrong, the PC Remote application will be unable to connect to your 8400 if you attempt
the connection by RAS null modem or through a modem.
5. Edit “update.ini” as necessary.
When updating your 8400 system software via an Ethernet network, you must
enter the IP address assigned by your network administrator into the up-
date.ini file. The update.ini file is normally installed on your PC in
the following location on your local drive:
• c:\Program Files\Orban\Optimod 8400\
When updating your 8400 system software via an Ethernet network, type the
following into the update.ini file, using a text editor like Notepad:
• LINE 1: The IP address that you entered in step (3.A) above, followed by a car-
riage return.
• LINE 2: The following characters: 8400_new.zip
For example:
###.###.###.###
[carriage return]
8400_new.zip
Do not enter the words “carriage return”; instead,
add a carriage return by pressing the
Enter key on your computer’s keyboard.
Setting Up an 8400 Memory Card
As of version 1.0 and higher, Orban supports SanDisk Flashdisk 8MB and 16MB Mem-
ory Cards (SanDisk part numbers SDP3B-8-101-B4 and SDP3B-16-101-B4 respec-
tively). Use only these cards if you wish to use a memory card with your 8400.
CAUTION
!
Do not install or remove a Memory card in the 8400 when the 8400 is powered. This
could cause the on-air audio to mute for 50 seconds.
To Next Page
Loading...
