2-56
INSTALLATION ORBAN Model 8400
1. Installing the card:
A) Remove power from the 8400.
B) Insert the Memory card in the front PC card slot.
The card cannot be “hot-swapped”; be sure to power down the 8400 before
installing it.
C)
Restore power to the 8400.
2. Backing up and restoring user presets to the memory card:
A) From the 8400 pop-up (main) Menu display, toggle the Locate button to select Sys-
tem Setup
, and then press the Enter button.
If the pop-up Menu isn’t onscreen, press the blue Control Knob or the Es-
cape button.
B)
From the System Setup screen, toggle the Locate button to select the Memory icon,
and then press the
Enter button.
C) Toggle the Locate button to highlight either user presets saved on the 8400 or
user presets saved on the memory card.
D)
Toggle the Locate button to highlight Copy, Copy All, or Delete, and then press the
Enter button to use that key functionality.
E) Toggle the Locate button to highlight Done and press the Enter button when you
have completed backing up or restoring user presets on the Memory Card.
Installing 8400 PC Remote Control Software
This section summarizes the procedure for installing 8400 PC Remote software on exist-
ing 8400s. You will find more detailed instructions in the .pdf file automatically installed
on your computer by Orban’s installer program, Setup8400_x-y_remote.exe,
where “x” and “y” represent the software version you are installing. (For example, for
version 1.0 software, x = 1 and y = 0.)
The PC Remote software is supplied on a CD shipped with your 8400. You can also
download it from www.orban.com
. Click “Downloads” and navigate to the 8400
folder.
Section 3 of this manual contains instructions for using the PC Remote software.
Installing the Necessary Windows Services
The Optimod PC Remote application uses Windows services to communicate between
your Windows PC and your 8400. If you wish to remote control your 8400 from your
To Next Page
Loading...
