2-40
INSTALLATION ORBAN Model 8400
a) Navigate to the each day of the week in turn, and use the rotary encoder to turn
the day on or off.
You can program the event to occur on as many days as you wish.
b)
Navigate to the Event Time field, and set the hour, minute, and second when the
automation event is to occur.
Automation events have a “start” time but no “stop” time. The 8400 will
stay in the state specified by an existing automation event indefinitely, until
its state is changed by another automation event or by another action (like a
user’s interacting with the front panel or with the PC Remote application).
c)
Navigate to the Event Type field and set the desired event. Starting with Version
2.1, you can recall any factory or user preset, and can activate Bypass mode (for
scheduled network testing) or Exit Bypass.
D) For Set By Date, set the desired date and time for the event, and specify the Event
Type.
E) Choose DONE and press Enter.
You will return to the automation event list. You may have to scroll the list (us-
ing the knob) to see the event that you just added.
5. To edit an existing event:
A) Using the knob, highlight the event you wish to edit.
B) Select the Edit button and press Enter. The edit screen appears.
C) Edit the event as desired.
D) Choose Done and press Enter.
6. To delete an event:
A) Highlight the event to delete with the knob.
B) Choose Delete and press Enter.
7. Choose
Done and press Enter to leave the Automation screen.
Security and Passcode Programming
If version 2.1 or higher is installed in your 8400, you can use multi-level passcodes to
control access to the 8400 via the front panel and via PC Remote. You can configure a
given passcode to allow one of the following five levels of access:
1. All Screens (i.e., administrator level)
2. All Screens except Security
3. Presets, Modify, Save, Memory, and Automation
To Next Page
Loading...
