_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for
IDEA
vacuum packing machines
Pag. 18 a 76
8
End of cycle. The lid opens automatically. Remove the container from the vacuum chamber.
7.2.2 Containers external
Phase
Description Image
1
Place the accessory (A) to operate the vacuum in containers externally, both in the vacuum
chamber and on the container lid. Make sure that the air intake device be open.
2
Keep pressed for 5”, to turn the vacuum
packing machine on.
3
Press UP/DOWN button, to select the Jars
(JAR) program.
4
Press SEL/OK to select the parameter
Vacuum and press UP/DOWN to set a value
between 10% and 99%.
_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for
IDEA
vacuum packing machines
Pag. 19 a 76
5
Press PLAY/PAUSE button, to start the
vacuum cycle.
6
Place one end of the suction device on the suction point in the chamber and slightly press the
other on the container lid, to start the vacuum.
7a
In case the vacuum was set at a level lower
than 99%, the pump switches off.
Remove the accessory and place it on the lid
of next container. Press PLAY/PAUSE button,
to start a new vacuum cycle.
7b
In case the vacuum was set at 99%, the pump
remains on.
Remove the accessory and place it on the lid
of next container.
8
Pressing STOP button at any time, it is possible
to interrupt the vacuum cycle immediately.
9
At the end of the vacuum cycle, remove the accessory from the vacuum chamber.
7.3 VACUUM packing FOODSTUFF in channelled bags, externally
CAUTION!
To vacuum pack products externally, it is necessary to use channelled vacuum bags (for
preservation or for cooking), that can be ordered to the dealer or directly to Orved S.p.A.
Pay attention that not all the vacuum bags available on the market are suitable for this use.
At the end of working day, unhook the piston pressing it towards and lower the lid in the rest
position. Doing so, the vacuum chamber will be protected from dirt and dust.
CAUTION!
This vacuum packaging procedure is suitable for dry and non sensitive to cushing foodstuff only
To Next Page
Loading...
