Orved IDEA 40 - VACUUM PACKING Foodstuff in Containers; Containers Placed in the Vacuum Chamber

_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for IDEA vacuum packing machines Pag. 16 a 76
7.2 VACUUM PACKING FOOdSTUFF IN containers
WARNING!
Verify that the selected containers were suitable to resist to the vacuum pressure.
At the end of working day, unhook the piston pressing it towards and lower the lid in the rest
position.
Doing so, the vacuum chamber will be protected from dirt and dust.
CAUTION!
Read carefully the information written at the beginning of Chapter 7.
Choose a container suitable for
vacuum packaging
Fill the container with foodstuff and
close the lid.
Filling limits:
• Solid products: 100%
• Broths, infusions: 1/2
• Vegetarian and meat sauces: 1/3
• Creams, cream-based sauces: 1/4
• Egg products or egg white: 1/6
Insert products cooled to +3°C to achieve the best result.
Lift the lid to limit switch and clip the piston, pulling it forward.
7.2.1 Containers placed in the vacuum chamber
Phase Description Image
1
Open the lid and make sure the vacuum
chamber and product to be packaged are
dry.
Take care not to dirty or wet the inner part.
Place the maximum number of black plates
(A) the vacuum chamber can contain,
according to the size of the product to be
packed.
_______________________________________________________________________________________
ORVED S.P.A Rev.01 – 09/2019 – cod. 1500735-00EN – User Manual for IDEA vacuum packing machines Pag. 17 a 76
2
Choose a container suitable for vacuum
packaging that fits in the vacuum chamber,
which remains at least 1 cm apart from the
packaging machine lid once closed.
It is possible to remove the sealing bar, if
necessary.
Make sure that the air intake device be open.
3
Keep pressed for 5”, to turn the vacuum
packing machine on.
4
Press UP/DOWN buttons, to select the Jars
(JAR) program.
5
Press SEL/OK to select the parameter
Vacuum and press UP/DOWN to set a value
between 10% and 99%.
6
Lower the lid and PLAY/PAUSE button, to start
the vacuum cycle.
7
Pressing STOP button at any time, it is possible
to interrupt the vacuum cycle immediately
and the vacuum chamber is uncompressed.
The lid opens automatically.
The machine comes back to the selected
program.