57
Guidance for tting the Pelvic Belt
This power wheelchair is equipped with back angle adjustment. Before starting your wheelchair
adjust the backrest to almost upright position and check if the locking mechanism on either side
has engaged. Observe the specications in the Instructions for Use Manual of the power wheelchair.
The following restriction must be observed:
If the C1000 features one of the following options, it must not be used for the transportation in
motor vehicles: electric seat tilt 30° with centre of gravity shifting; electric back angle adjustment;
electric seat height adjustment; platform for respirator; or tray, swing-away to the side.
Pass one end of the pelvic belt through the space between the armrest
skirt guard and seat cushion. Now clip the pelvic belt buckle onto the
"Anchor Pin" previously screwed to the backrest side frame anchoring
plate. Then repeat on the opposite side for the other half of the pelvic belt.
C 1000 showing the correct positio-
ning of the tie-down straps.
To Next Page
Loading...
Need help?
General
