58
6 Product Specic Instructions – Power Wheelchairs
– Skippi –
For assembly of the 491S00=SK024 xation kit you will need the following tools:
ring wrenches sizes 13 and 17, Allen wrench size 10.
Attaching the anchoring points to the product
On the left and right side, screw the
included „Anchor Pins“ into the bore
holes provided in the seat angle.
No extra brackets are required for
the front of the wheelchair as the
cross tube has two integral anchoring
brackets.
No extra brackets are required for
the rear of the wheelchair as the seat
angle has two integral anchoring
brackets.
Guidance for tting the Pelvic Belt
Pass one end of the pelvic belt through the space between the armrest
skirt guard and seat cushion. Now clip the pelvic belt buckle onto the
"Anchor Pin" previously screwed to the backrest side frame anchoring
plate. Then repeat on the opposite side for the other half of the pelvic belt.
Skippi showing the correct positio-
ning of the tie-down straps.
This power wheelchair is equipped with back angle adjustment. Before starting your wheelchair
adjust the backrest to almost upright position and check if the locking mechanism on either side
has engaged. Observe the specications in the Instructions for Use Manual of the power wheelchair.
This power wheelchair might be equipped with an electric or mechanical seat tilt option. Before
starting your wheelchair, the seat tilt must be adjusted to 0°.
To Next Page
Loading...
Need help?
General
