Owon HDS-N series - Page 73

OWON HDS-N Series Handheld DSO & DMM 8-Advanced Function of Oscilloscope
4. Press F2 to switch between channel CH1 and CH2 and the current status of channel shows
.
ch over Format dB and Vrms.
SITION (red) ,
z two prompts circularly will display at the bottom-left of the screen
.
e) and the screen show as follows:
hree prompts circularly will display at the bottom-left of the
z two prompts circularly will display at the bottom-left of the screen
.
) and the screen show as follows:
on the top left.
5. Press F3 to switch over Window including Hamming, Rectangle, Blackman and Hanning
6. Press F4 to swit
7. Press F5 to zoom in or out the waveform, the magnification includes ×1, ×2, ×5, ×10.
8. ① If the FFT source is CH1, press VOLTS PO
z One of the following three prompts circularly will show at the bottom-left of the screen
when the format is dB.
▲/▼— CH1 Volts/Div
▲/▼ — FFT Zero
▲/▼ — FFT dB Scale
One of the following
when the format is Vrms
▲/▼— CH1 Volts/Div
▲/▼ — FFT Zero
Press VOLTS POSITION (blu
▲/▼ — CH2 OFF
② If FFT source is CH2, press VOLTS POSITION (blue),
z One of the following t
screen when the format is dB.
▲/▼— CH2 Volts/Div
▲/▼ — FFT Zero
▲/▼ — FFT dB Scale
One of the following
when the format is Vrms
▲/▼— CH2 Volts/Div
▲/▼ — FFT Zero
Press VOLTS POSITION (red
67