Selecting HotSync setup options
125
5.
Click the Modem tab to display the modem settings and adjust the options as
needed. See “Conducting a HotSync operation via a modem” later in this
chapter for more information.
6.
Click OK.
To set the HotSync options on a Mac computer:
1.
Double-click the HotSync Manager icon in the Palm folder.
2.
Click the HotSync Controls tab and select any of the following options.
Serial Port
Identifies the port that HotSync Manager uses to communicate
with the cradle/cable. The Palm Desktop installation software
automatically detects the port to which you connected the
cradle/cable. If necessary, you can change the port selection.
NOTE
You r
handheld cannot share this port with an internal
modem or other device.
Speed
Determines the speed at which data is transferred between
your handheld and Palm Desktop software. Try the As Fast As
Possible rate first, and adjust downward if you experience
problems. This setting allows Palm Desktop software and your
handheld to find and use the fastest speed.
To Next Page
Loading...
Need help?
General
