Panasonic AAD03011 - Page 39

No.
Parameter name
Setting range
Factory
setting
data
P30 MONITOR SELECT 0࡮1
ڎ P31 LINE SPEED MULTIPLIER
0.1㨪100
3.0
P32 MAX. OUTPUT VOLTAGE(V) 0 ࡮ 1㨪500 0
P33 OCS LEVEL(%) 1㨪200 140
ڎ P34 CARRIER FREQUENCY(kHz) 08㨪15.0
P35 COMMUNICATION STATION No. SETTING 1㨪31 01
P36 COMMUNICATION SPEED 48࡮96࡮192 96
P37 STOP (BIT) 1࡮2
P38 PARITY CHECK 0࡮1࡮2
P39 TIMEOVER DETECT(s) 0࡮0.1㨪60.0 000
P40 SEND WAIT TIME (ms) 1㨪999 001
P41 P REGION PASSWORD 0࡮1㨪999 000
P42 SETTING DATA CLEAR 0࡮1࡮2
P43 INPUT SIGNAL LOGIC SETTING 0㨪31 0
ڎ P44 SAFETY SENSOR RESPONSE TIME(ms) 0 ࡮ 1㨪999 10
ڎ P45 ARRIVAL SIGNAL RESPONSE TIME(ms) 1㨪999 10
P46 ENCODER FAULT DETECT TIME(s) 0࡮0.1㨪2.0
P47 ARRIVAL SW FAULT DETECT TIME(s) 0࡮0.1㨪10 0
P48 RY1 FUNCTION SELECT 0㨪7࡮r0㨪r7 7
P49 RY2 FUNCTION SELECT 0㨪7࡮r0㨪r7 4
P50 RY3 FUNCTION SELECT 0㨪7࡮r0㨪r7 5
P51 NO. OF MOTOR POLES 2࡮4࡮6
P52 ENCODER CONSTANT 50㨪999 512
P53 㧙 㧙 0
P54 㧙 㧙 1.0
P55 㧙 㧙 00
P56 㧙 㧙 10
P57 㧙 㧙 00
P58 㧙 㧙 50
ڎ P59 OVERLOAD DETECTION FREQUENCY 1 (Hz) 0 5㨪250 10.0
ڎ P60 OVERLOAD DETECTION FREQUENCY 2 (Hz) 05㨪250 50.0
ڎ P61 OVERLOAD DETECTION CURRENT 1 (A) 01㨪100 1.2
ڎ P62 OVERLOAD DETECTION CURRENT 2 (A) 0. 1㨪100 1.2
ڎ P63 OVERLOAD DETECTION JUDGEMENT TIME (ms) 0࡮1㨪999 10
37
0
10
0
1
0
0
4