No.
䃨
OBSTACLE JUDGMENT FREQUENCY
RATIO (LOW SPEED) (%)
0 䌾100
䃨
OBSTACLE JUDGMENT FREQUENCY
RATIO (HIGH SPEED) (%)
OBSTACLE
JUDGMENT CHANGE
FREQUENCY (Hz)
OBSTACLE DETECTION
JUDGMENT TIME (ms)
0
䌾
100
䃨
㩷
0.5䌾250 5.0
䃨
0䊶1䌾999 100
䃨
200
䃨
㩷
0.0
䃨
㩷
0.0
䃨
0.0
䃨
㩷
3.0
䃨
3.0
0
0
0
䃨
1.0
䃨
100
䃨
䃨
0
Note1) The
䃨㩷
mark indicates parameters that can be changed during the
inverter is in operation.
Note2) Parameters P53 to 58(Function cannot be used) indicate the data
is set in factory and cannot be changed.
Note3) For the communication parameters P35 to 40, always turn off the
power supply after the data has been set. The set value will be
effective after the power supply is turned on again.
38
P64
P65
P66
P67
P68
P69
P70
P71
P72
P73
P74
P75
P76
P77
P78
P79
P80
P81
50.0
70.0
0䊶0.1䌾500
0䊶0.1䌾500
0.0䌾10
0.0䌾10
0.0䌾10
0䊶1䊶㪉
0䊶1
0䊶1䊶㪉
0.1䌾10
1䌾999
0䊶0.1䌾10
00䊶1䊶㪉
0.00䊶0.1䌾500
100䌾999
Parameter name
START CONFIRMATION TIME (ms)
Setting range
Factory
setting
data
FORCED ON OPERATION
JUDGMENT TIME (s)
FAULT ON OPERATION
FORCED OPERATION TIME (s)
FAULT ON OPERATION
OPEN ARRIVAL HOLD TIME (s)
REPEAT
OPEN ARRIVAL HOLD TIME (s)
REPEAT
CLOSE ARRIVAL HOLD TIME (s)
S-SHAPED ACCELERATION/
DECELERATION FUNCTION
STOP SELECT IN OPEN/CLOSE OPERATION
NO ARRIVAL SIGNAL SELECT
SLIP ARRIVAL JUDGMENT
FREQUENCY (Hz)
SLIP ARRIVAL JUDGMENT TIME (ms)
SLIP OPEN ARRIVAL SUBSTITUTE
SELECT (s)
SAFETY SENSOR FUNTION SELECT
FAULT OPEN OPERATION FORCED
OPEN OPERATION TIME (s)
To Next Page
Loading...
