Panasonic AFPX-C30T

FP-X (A: Available, N/A: Not available)
Address Name Description
Read
-ing
Writ-
ing
DT90022
Scan time (current
value)
Note)
The current scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
ms
Example: K50 indicates 5 ms.
A N/A
DT90023
Scan time (minimum
value)
Note)
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
ms
Example: K50 indicates 5 ms.
A N/A
DT90024
Scan time (maximum
value)
Note)
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1
ms
Example: K125 indicates 12.5 ms.
A N/A
DT90025
Mask condition
monitoring register
for interrupts
(INT0 to 13)
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
A N/A
DT90026
Not used
-
N/A
N/A
DT90027
Periodical interrupt
interval (INT24)
The value set by ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
A N/A
DT90028 Sample trace interval
K0: Sampling by the SMPL instruction
K1 to K3000 (x 10 ms): 10 ms to 30 s
A N/A
DT90029
Not used
- N/A N/A
DT90030
Message 0
The contents of the specified message (Data
length) are stored in these special data
registers when F149 (MSG) instruction is
executed.
A N/A
DT90031
Message 1
DT90032
Message 2
DT90033
Message 3
DT90034
Message 4
DT90035
Message 5
DT90036
Not used
-
N/A
N/A
Note) Scan time display is only possible in RUN mode, and shows the operation cycle time. (In PROG.
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared each time the mode is switched from RUN to PROG.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com