Panasonic DP-2330

40
DP-2330/3030
DEC 2004
Ver.2.0
DP-2310/3010
2.7. Updating the Firmware
The Quickest and Most Easiest Method of Updating the Firmware is to use the Network Firmware
Tool (FUP) using Ethernet LAN Port and a Crossover Cable.
The Network FUP Tool version must be 3.XX or higher, and it can be found on the Panasonic Document
Management System CD-ROM included with the main unit or on the CD-ROM included with the PCL or
PS/PCL options.
Refer to the Firmware Update Operation Instructions, Service Notes (8.1. or 8.2) for additional
details.
2.7.1. Firmware Configuration
A. Hardware Configuration
This machine is controlled by three (3) CPUs which are located on the System Control (SC) PC
Board, the Scanner Printer Control (SPC) PC Board and the Panel Control (PNL) PC Board.
B. SC PC Board Firmware
The 4 MB Program Memory (F-ROM) is integrated on the SC PCB. Two (2) Optional Expansion 8 MB
Program Memory (FRM8 PCB) can be installed into SLOT 1 and SLOT 2.
The Firmware to be written into the 4 MB onboard, the 8 MB of SLOT 1 / SLOT 2 depends upon the
configuration of the Standard, PCL or PS Options.
(1) Standard
The Standard Program (1) is only written into the 4 MB onboard, which is assigned as ROM
Code (A).
SC PC Board
Standard
Confi
g
uration
With PCL Option
Confi
g
uration
With PS Option
Confi
g
uration
On Board (A)
4 MB
(B)
4 MB
(D)
4 MB
PC
(1) (2) (5)
CPU
4 MB
Program Program Program
Ethernet Port
F-ROM
PC
USB Port Slot 1 (C) 8MB (E) 8MB
(3) (6)
Program
Program
8 MB
2 MB
(a)
4 MB
(a)
FRM8 PCB
(4) (7)
Flash Memory
Card
Font
4 MB or 8 MB
4 MB
(b)
4 MB
(b)
Slot 2
8 MB
FRM8 PCB
PNL PC Board
Panel Control Program (Display & Key In)
CPU
4 MB
Bitmap Data
F-ROM
Font Data
SPC PC Board
CPU
512 KB
Scanner Control Program
F-ROM
Printer Control Program
Font