6.5 Opening the imprinter door
6.5.1 Opening the pre-imprinter door
• The procedure for opening the pre-imprinter door varies by purpose.
• For details about operation panel, refer to "
5 Operation Panel" (page 20).
6.5.1.1 When installing/uninstalling the imprinter unit and ink
cartridge
1. Remove all documents from the exit tray.
2. Press the menu button (
).
3. Use or of the cursor button to select [Maintenance].
4. Press the Enter button ( ) to complete your selection.
• The Maintenance
screen is displayed.
5. Use
or of the cursor button to select "Pre-Imprinter setting".
6. Press the Enter button ( ) to complete your selection.
7. Press the Start/Stop ( ) button.
• The exit tray moves up, and the unit powers of
f automatically. Pay attention that your fingers or
anything do not get pinched.
8. Raise the exit tray (
).
6.5 Opening the imprinter door
35
To Next Page
Loading...
