7.4 Using Count Only Mode
When using Count Only Mode, you can count the number of documents without scanning images of the
documents. For details about operation panel, refer to "
5 Operation Panel" (page 20).
If Count Only Mode Shortcut is enabled, press the menu button (
) for 1 second or more, and then follow
the procedure from step 6.
1. Press the menu button ( ).
2. Use
or of the cursor button to select "Maintenance".
3. Press the Enter button ( ) to complete your selection.
4. Use or of the cursor button to select "Count Only Mode".
5. Press the Enter button (
) to complete your selection.
LCD display:
6. Set the documents on the feed tray
.
7. Press the Start/Stop button (
).
• Begins document feeding and counting. The number of pages will be displayed on the LCD.
8. Remove the documents from the exit tray
.
• To count more documents, repeat steps 6 to 8.
9. Press the Back button (
) to exit Count Only Mode.
Notice
• If a paper jam or double feed error occurs, set the document on the feed tray again, and then repeat
the procedure from step
6.
7.4 Using Count Only Mode
61
To Next Page
Loading...
