Panasonic KV-S8147 - Installing the Imprinter as the Pre-Imprinter

10.1.1 Installing the imprinter as the pre-imprinter
1. Open the pre-imprinter door (
page 35).
Note
• Move up the exit tray using the operation panel.
2. Pass the cable through the opening of the pre-imprinter door.
3. After aligning the pins ( ) on both sides with the slits in the body of the scanner ( ), insert the pins ( )
until they are immobilized by the springs ( ).
1
2
3
4
4. Install the ink cartridge (page
90).
10.1.1 Installing the imprinter as the pre-imprinter
84