3. Fan the documents.
• Documents that have been stapled together or stacked together (as in a file folder) will need to be
separated.
Fan the stack of documents to separate all the edges.
Hold both ends and bend the documents as shown in the illustration.
To flatten the documents, hold firmly and pull them apart as shown in the illustration.
Repeat these steps as necessary.
4. Carefully align the documents.
5. Place the documents on the feed tray (
) with the side to be scanned facing up. Then push the
documents in the direction of the arrow until they stop.
Notice
• The height of the documents should not exceed the limit mark ( ) on the document guide.
Exceeding the limit mark may cause a paper jam or skewing.
7.2 Scanning Documents
44
To Next Page
Loading...
