Start-up menu
From the menu on the Setup screen, you can access
the following settings screens to configure the start-up
settings:
1. Language (® Page 159)
If your prefer to use a language other than English,
change your language settings first.
2. IP Address (® Page 159)
You must configure the IP address settings in order
to connect to the network and use the KX-NT400.
3. IP Port (® Page 160)
If your network uses different ports than the default
settings, change these settings to match those of
your network. For a list of defaults, see "Network—
IP Port (Page 176)".
4. QoS (® Page 161)
If your network uses QoS (Quality of Service) for
voice communication, configure these settings to
match those of your network.
5. Maintenance (® Page 162)
View the MAC addresses for the KX-NT400’s
network adaptors, and test connections to other
network devices.
6. Firmware Version Update (® Page 163)
If a new firmware version is released, perform a
firmware upgrade to install the latest version.
For details about firmware, consult your dealer.
7. Initialize Settings (® Page 165)
Initializing the settings resets the KX-NT400 to its
factory shipment state. Performing this operation
erases all data (contact lists, camera settings, etc.).
8. Firmware Version (® Page 165)
View the installed version of various firmware
components.
9. Error Log (® Page 166)
View system error messages.
Exiting the start-up settings
1. Press Close on the Setup screen.
Note
• When you change certain settings, the
KX-NT400 restarts automatically after you
press Close on the Setup screen.
For details, see "Restarting the KX-NT400
(Page 168)".
158 Operating Instructions Document Version 2010-01
Installation and Settings
To Next Page
Loading...
