Administrator Options
Network—IP Address
These parameters are editable only during setup, after connecting the KX-NT400 to a PBX. On the Options
screen, you can only view these parameters. For details about editing these parameters, see "IP Address
Settings (Page 159)".
Parameter Name
Description Value Range Default Setting
DHCP Specify whether DHCP is used. Enable, Disable Enable
VoIP IP Address Enter the VoIP IP address when DHCP is
disabled.
Valid IP Address –
Application IP
Address
Enter the application IP address when DHCP
is disabled.
Valid IP Address –
Subnet Mask Enter the subnet mask when DHCP is
disabled.
128.0.0.0–
255.255.255.254
–
Default Gateway Enter the default gateway address when
DHCP is disabled.
Valid IP Address –
PBX IP Address 1 Enter the PBX IP Address 1. Valid IP Address –
PBX IP Address 2 Enter the PBX IP Address 2. Valid IP Address –
PBX Change Time Enter the length of the time before the failover
process starts.
30–300 seconds 60 seconds
Network—IP Port
These parameters are editable only during setup, after connecting the KX-NT400 to a PBX. On the Options
screen, you can only view these parameters. For details about editing these parameters, see "IP Port Settings
(Page 160)".
Parameter Name
Description Value Range Default Setting
PTAP Server
(IP Port 1)
Enter the IP port number for the PTAP server. 1024–65535 9300
PTAP Client
(IP Port 1)
Enter the IP port number for the PTAP client. 1024–65535 9301
PTAP Server
(IP Port 2)
Enter the IP port number for the PTAP server. 1024–65535 9300
PTAP Client
(IP Port 2)
Enter the IP port number for the PTAP client. 1024–65535 9301
Network—QoS
These parameters are editable only during setup, after connecting the KX-NT400 to a PBX. On the Options
screen, you can only view these parameters. For details about editing these parameters, see "Quality of Service
(QoS) Settings (Page 161)".
176 Operating Instructions Document Version 2010-01
Appendix
To Next Page
Loading...
