Panasonic KX-NT400

Setting Up the KX-NT400
This section describes the settings that you can
configure when you start the KX-NT400.
IMPORTANT
• The KX-NT400 requires 2 IP addresses for its
operation. Before configuring the start-up
settings, make sure that 2 IP addresses are
available for the KX-NT400.
• Using the PC Maintenance Console to program
the PBX, you must set the Incoming Call Log
Memory for the KX-NT400 to 0. If you do not
change this setting, missed calls will not be
handled correctly on the Calls screen or the
Feature Key screen (in Call List mode).
For details about the Incoming Call Log
Memory setting, see the PBX’s documentation.
• The "ringing" icons on the Contacts screen (for
example, ) do not appear if you use the
default settings. To make the ringing icons
appear, you must set the DSS key mode for
Incoming Call setting to "ON or Flash" using the
PC Maintenance Console. For details, see the
PBX’s documentation.
Accessing the Start-up Settings
1. Connect the KX-NT400 to an Ethernet cable
capable of delivering power (PoE compliant), or use
an optional AC adaptor to supply power.
2. Connect the KX-NT400 to the network.
Note
The first time you start the KX-NT400, the
calibration screen appears. Follow the
instructions to calibrate the screen. For details,
see "Display Settings (Page 113)".
3. On the start-up screen, press Setup.
4. Select the item for the settings you want to
configure.
Document Version 2010-01 Operating Instructions 157
Installation and Settings